|
Overall view with new screen, fuel cell, and mounted top box from driver's left side.
(PA270111.JPG)
PA270111
Date: 10/28/04
Views: 971
|
Same view as at left just a little closer.
(PA270112.JPG)
PA270112
Date: 10/28/04
Views: 831
|
Rider's right side photo.
(PA270113.JPG)
PA270113
Date: 10/28/04
Views: 891
|
Same photo slightly lower angle. (PA270114.JPG)
PA270114
Date: 10/28/04
Views: 775
|
|
Close up of fuel cell with top box mounted. From this photo you can see that box is centered over rear axle.
(PA270115.JPG)
PA270115
Date: 10/28/04
Views: 1120
|
Ass end view of bike illustrates height of box well. I need to measure height against a box mounted on a Givi rack.
(PA270116-
PA270116_2
Date: 10/28/04
Views: 788
|
Rear quarter view of fuel cell and box set up. I will attempt to paint and color match the box to the new bike this weekend.
(
PA270117_2
Date: 10/28/04
Views: 1004
|
Same view as previous. Will post more pictures after painting the box lid.
(PA270117.JPG)
PA270117
Date: 10/28/04
Views: 818
|
|
Left side view of top box and mounting. Handling is improved over stock mounting.
(PA270118.JPG)
PA270118
Date: 10/28/04
Views: 728
|
I just have to figure out where to mount a jug or camelback for LD riding hydration.
(PA270119.JPG)
PA270119
Date: 10/28/04
Views: 715
|
Head on view. Windscreen is nice and Hella's put the light far down the road and light up a good portion of the shoulder as wel
PA270130
Date: 10/28/04
Views: 860
|
Dash view showing GPS and radar detector mounting. Datel voltmeter can be see as well as Sigma cyclometer. (PA270131.JPG)
PA270131
Date: 10/28/04
Views: 967
|
|
Left side view. Switch gear for Hella's is visible as is Mag-Knight tank protection.
(PA270132.JPG)
PA270132
Date: 10/28/04
Views: 877
|
Rear view of Tanji cell and mounted Givi. Additional red reflectors added.
(PA270133-2.jpg)
PA270133_2
Date: 10/28/04
Views: 765
|
E460 removed to show fabricated mount.
(PA270134-2.jpg)
PA270134_2
Date: 10/28/04
Views: 794
|
Rear view showing flat bar attachement points.
(PA270135.JPG)
PA270135
Date: 10/28/04
Views: 698
|
|
Give mount from all angles.
(PA270136-2.jpg)
PA270136_2
Date: 10/28/04
Views: 743
|
Givi universal mount removed to show tapped holes where mount is bolted to aluminum flat bar.
(PA270137.JPG)
PA270137
Date: 10/28/04
Views: 675
|
Mounting plate attached to flatbar shown with stainless hardware used to bolt universal mount to fuel cell. (PA270138.JPG)
PA270138
Date: 10/28/04
Views: 651
|
E460 and mount removed to show "flat bed" FJR.
(PA270139-2.jpg)
PA270139_2
Date: 10/28/04
Views: 684
|
|
The welds on the Dean Tanji fuel cell are impeccable and handling, even loaded with an E460, is better than on the stock Givi ra
PA270140
Date: 10/28/04
Views: 747
|
Much less wind buffeting than when case is mounted in stock location. (PA270141.JPG)
PA270141
Date: 10/28/04
Views: 860
|
Another view of Tean Tanji fuel cell, my flatbed FJR.
(PA270142.JPG)
PA270142
Date: 10/28/04
Views: 2140
|
Angled photo of entire bike. (PA270143.JPG)
PA270143
Date: 10/28/04
Views: 700
|
